Tuesday, February 12, 2013

Basic Resistance Workout Principles and Programming Part I


Basic Principles:

            Muscular strength and endurance are considered one of the components of fitness. The development of muscular strength and endurance helps to improve and functional physical capacity, as per Hoeger et al5. Other benefits in developing and/or improving muscular strength and endurance are: greater work efficiency, less chances of muscle injury, reduced risk of low back pain, improved sports performance, quicker recovery from hard work, and improved ability to meet emergency situations 3. This article is about the basic principles underlying the design of a muscular strength and/or endurance-training program.

In designing a resistance / strength training program, there are basic principles to follow. The first being that in order to develop some strength, the muscle must be made to work beyond what it is used to. This is the principle of overload1, 2, 3. How much overload to give will be discussed later on.  This is one of the most basic principles in developing strength.

When the body is given an overload, it takes the body some time to adjust to that particular workload. After the body has adjusted to that workload, it will be time to increase it again. This is second principle, the principle of progresssion1, 2, 3. The load / intensity must be increased over time as the body adapts to the previous load. This is to continuously produce improvements over time.

Some authors combine the first two principles, progressive overload3. But basically, it is still the same two principles rolled into one.

The third principle is specificity1, 2, 3. This principle simply states that that type of stress placed on the body will produce specific adaptations. For example, if one wants to increase strength of the chest area, then an exercise such as the bench press, should be given. If the person is involved in sports, then giving exercise, which closely mimic the movement, should be prescribed. If, for example, the jumping ability of a player needs to be improved, then giving exercises such as the squat and the power exercises, such as the hang clean or the clean and jerk, should be part of the program.

The fourth principle is on rest and recovery. The ACSM recommends at least 48 hours between workouts for each muscle group 2, 7. This allows the muscle time to recover from the previous workout. The rest principle also refers to rest in between sets and exercise in a single workout.

Components of a workout session:

            It is suggested that all exercise training sessions have the following components: warm-up, stretching, conditioning, and cool down phases. The ACSM recommends that the warm-up be of low to moderate intensity aerobic and/or muscular endurance activity for about 5 to 10 minutes. This is to in increase the body temperature and reduce the potential for after exercise muscle soreness. It also allows the body to adjust to the change in physiological and biomechanical demands placed on the body during the actual exercise proper. 3, 8

Fig. 1 A football player doing a dynamic warm-up

The stretching phase is distinct from the warm-up and cool-down and can be performed either after the warm-up or cool down phases.8

            The conditioning phase, or the exercise proper, is where one performs the aerobic or resistance exercise itself. If the person is involved in sports, sport related activity is also performed here 3,6,8. This will be discussed below.

            The last portion is the cool-down phase. Similar recommendations as the warm-up, 5 to 10 minutes of low to moderate intensity aerobic or muscular endurance activity. The purpose is to return the heart rate (HR) and blood pressure (BP) to resting, or close to resting levels, and allow removal of metabolic by-products from the muscles. 3, 8

Program Design:

            In designing a resistance training workout, it is recommended to use the FITT principle. FITT stands for:

                                    F – Frequency
                                    I – Intensity
                                    T – Time
                                    T – Type

            Frequency stands for how often should one work out 4. For general fitness, the ACSM recommends that strength training should be done two to three times a week. That is non-consecutive days for most major muscle groups.  Two consecutive days can be done if a split type of workout is given. A split type of workout is when two different muscle groups are exercised of consecutive days.8 For example, working the muscles of the upper extremity on day 1. Day 2 will then consist of working the muscles of the lower extremity. The third day will be the rest day.

            Intensity is the difficulty of the resistance, or load assigned to the major muscle groups 4. A percentage of the 1 repetition maximum, commonly called the 1 RM,  is used. What the goal is for resistance training will determine the percentage assigned.  (A more detailed discussion on the use of the 1 RM will be discussed in part II.)

For general fitness, the ACSM recommends a moderate load of around 60% to 80% of the 1 RM 8. This should allow around 8 to 12 repetitions per exercise. This intensity is suggested for people aged less than 50 to 60 years of age. For older (50 to 60 years of age) and/or more deconditioned individuals, the suggested intensity should allow a repetition range of 10-15 repetitions 8. This would correspond to a score of 5 to 6 on a 10-point RPE scale 5. The suggested intensity for that particular repetition range, as per the ACSM, 60% to 70% of 1-RM 8. The NSCA, on the other hand, recommends < 67% of 1-RM 1,2.

Fig. 2 Borg Scale
             Type stands for the mode of exercise 4. While for some authors, this a given because the obvious exercise is resistance/strength training. However, for Fahey et al, the type of resistance exercise should also be considered 4. Fahey et al suggests exercises for the neck, upper back, shoulder, arms, chest, abdomen, lower back, thighs, buttocks, and calves 4. The ACSM recommends exercises for the major muscle groups: chest, shoulders, abdomen, back, hips, legs, and arms 5, 8. While the NSCA recommends exercises for the following muscle groups: chest, shoulders, upper back, hips/thighs, biceps, triceps, abdominals, and calves 2

            Regardless of what you want to follow, the suggestion is that there should be 8 to 10 exercises that would cover every major muscle group 5, 8. About one exercise per muscle group at the basic level, or beginning lifter 2. Exercises suggested should include multijoint , or compound, exercises that involve more than one muscle group 8. An intermediate lifter may include two exercises per muscle group 2.

            Time denotes the length of time one performs the exercises, or workout 5. It can also be the amount of time one performs a particular exercise 3, 4 .

            If we speak about the amount of time to perform a particular exercise, we talk about the number of repetitions, or reps, and the number of times these repetitions are repeated, or sets. The choice of the number of reps depends upon the goal of the individual. At the basic level, when training beginners, the suggested training sets and reps are: 1 set of 8-12 reps for young adults; 1 set of 10 to 15 reps for adults greater than 50 years old 3. This is the threshold of training. Optimally, there should be 1-3 sets of the former and latter 3.
            As for the length of time to perform a workout, the ACSM suggests a workout time of no more than hour. As higher dropout rates are associated with longer, more difficult workouts 5. This is applicable to beginners or older adults.

            In prescribing strength training exercise to beginners and older adults, a little common sense goes a long way. Prescribing too much too soon, especially for untrained people will produce a high dropout rate. While the intensity of the exercise is prescribed in the article, one must not assume that the trainees can life the load immediately. It may be prudent to start at a much lower intensity with one set in the beginning and work it up to the prescribed set and rep range. This is to allow the beginner to learn the movement and build strength up without too much muscle soreness involved.

            Using the percentage of the 1-RM to prescribe the number of reps and sets will be discussed in part II of resistance exercise programming.



Bibliography:

1.     Baechle, Thomas R. and Roger W. Earle “Essentials of Strength Training Conditioning 3rd Ed.” 2008

2.   Baechle, Thomas R. and Roger W. Earle “Essentials of Personal Training” 2004

3.   Corbin, Charles B., Gregory J. Welk, William R. Corbin, Karen A. Welk, and Cara L. Sidman “Concepts of 
      Fitness and Wellness 9th edition” 2011

4.   Fahey, Thomas D., Paul M. Insel, and Walton T. Roth “Fit and Well: Core Concepts and Labs in Physical 
      Fitness and Wellness 9th edition” 2011

5.   Franklin, Barry A. senior editor “ACSM’s Guidelines for Testing and Prescription 6th ed.” 2000

6.   Hoeger, Werner W. K. and Sharon A. Hoeger “Lifetime Physical Fitness and Wellness 11th edition” 2011

7.   Wilmore, Jack H., David L. Costill and W. Larry Kenney “ Physiology of Sport and Exercise Fourth 
      Edition” 2008

8.   Thompson, Walter R, senior editor “ACSM’s Guidelines for Exercise Testing and Prescription 8th ed.” 
      2010